Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I would like to ask. What do you think is it possible to run AIR-CAP2602E-A-K9 without antenas?
Reason is we have this ap without antenas and clients can not connect but wlc show everything ok
Hi all,I would like to ask your opinion about following:We have a VPN configured with one of our service provider.The goal is to allow them to access devices connected behind our DMVPN Spokes (devices in 10.80.0.0/12). Their networks are 192.168.3.0/...
I have an following issue installing DCNM with support of SAN devices on a Windows 2012 RC2 x64Bit I get the following error when starting the installer: Flexeraaxx$aaa: Windows DLL failed to load at Flexeraaxx.af(Unknown Source) ...
Hi all,I would like to have a question regarding software upgrade Nexus5548 from Version 5.2 (1) N1 (1) to Version 6.0 (2) N2 (5).We have to play on all Nexus switches, a new NS-OS software.Since we also need to create an action plan to roll back th...
You posted this DiscussionEditDeleteerror message on VSSUnanswered Questionjozefstaruch 12 months ago Hi All, I would like to ask if you have see following error message and if it is realated to problem below.. Aug 24 18:15:56 core.schmid.local ...
I have this update from cisco: This is not buggy behavior. I have both researched for known issues, andchecked with the dev folks, as well as have tried to reproduce the issueextensively but have not seen this behavior. After all these attemptsthis i...
Hi Rasika,It is clear about vlan 427 and this needs to be mapped to WLAN 12... This should be fixed.. if I do show cdp nei detal i see that AP have ip address from native vlan 499Only think which is now confusing me is that AP has Native VLAN ID 1...
Hi Rasika,It makes sence thank you ... Just one more question I have another location with simmilar setup which is working. Vlan for scanners is ok but I do not unerstand how native VLAN can work in this case..DHCP server ---- >router-- > switch...
Hi Rasika,Thank you for helping ,, I added command you requested according the output . the mapping is not goodwhat do you think?(Cisco Controller) >show ap config genera vluluksap0001...
