I have a T1 CAS circuit from sprint configured for E&M wink. The customer has requested that ANI be delivered over this circuit. Sprint has a service called real time ANI that delivers the ANI in the DNIS digits. For ex: the digits *4045551212*3115* ...
Is it possible to configure the Call Manager so that an incoming call to an IP phone will also ring on an overhead bell that is attached to an FXS port? Has anyone done this? I need to find a way to make this happen.Thanks,Michael
I have a major issue with this. We are saying to our customers:"we want you to have the best meeting experience possible, we encourage you to hold face to face meetings over video, we want you to be able to connect to anyone in the world, we want you...
You can add a default incoming cor list of internal so all IP phones will be able to see the internal cor list and call 4002. ! call-manager-fallback max-conferences 4 ip source-address 192.168.5.1 port 2000 max-ephones 5 max-dn 12 dialplan-pattern 1...
You will need a PRI and QSIG software in the Nortel. On the CallManager side use a 2651 or 3700 series gateway running MGCP (7200 or 7500 will not support MGCP to CallManager). In the CallManager gateway configuration page you configure the QSIG conn...
A carrier will not usually allow you to pass an ANI unless the number is a DID on that trunk. In other words, if you have a PRI that delivers 5000 5099 to the call manager, most carriers will only allow an ANI of 5000 5099 to be delivered. Does...
Hi Jason,Thanks for the tip. I tried FGD (and even EANA for giggles) with no luck. The E&M channels would not go into an idle state and calls would not pass inbound or outbound.I was hoping someone out there had successfully configured Sprint's real ...