Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Has anyone had any experience of deploying directional antennas instead of omni's in open plan office environments with 10ft ceilings.
The particular environment has multiple floors across 4 building with Atrium's between the building where s...
Folks,When running OTV in Unicast mode, is support for Multicast traffic enabled across the Overlay automatically?Is there any additional configuration required to support Multicast frames across the Overlay or are they forwarded just like Broadcast ...
Hello,I am trying to tunnel STP over and EoMPLS tunnel.I have an ME 3600X and 2911 ISRG2 acting as PE's.I have 2 Cisco 2960 switches acting as CE's (this is a test environment)The layer 2 vc's are up on both PE's but STP bpdu are notbeing forarded be...
Hi,I am looking aat desgning a Guest Wireless Network using Dual Anchor and Dual Foreign (Internal) WLC's for Redundancy.For scalability I want to assign a single Guest SSID to multiple vlan interfaces on the Guest Controller using Interface Groups a...
Hi,I am looking aat desgning a Guest Wireless Network using Dual Anchor and Dual Foreign (Internal) WLC's for Redundancy.For scalability I want to assign a single Guest SSID to multiple vlan interfaces on the Guest Controller using Interface Groups a...
Thanks Flavio.
The cell size and cell overlap on the same floor looks ok due to the large number of AP’s on each floor.
I will test how strong the signal is between floors.
Have you ever seen issues with the signal reflecting off the floor when...
I ran into this problem also.
I was able to get around the global filter on the Overlay by manually configuring the the mac addr of the HSRP Group to be outside of the default range.
in vlan 900
hsrp 900
mac-addr 0000.0000.0001
You will need to enable the DATA license. One the license is purchased it can be enabled on the Universal image.An evaluation license for DATA can also be enabled for a trial period
Sean,Thanks for th reply.My transport between the DC does not suport Multicast routing - Only unicast.I have read that enabling an IGMP querier in the DC will allow for IGMP messages to be forwarded across the Overlay?Colm
Folks,I have this issue resolved.There were reported bugs in earlier version of code for the ME3600X which dropped MSTP and RSTP BPDU's.Also there are 2 different use cases for using the L2protocol command:1, When creating a service instance between ...
