Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can see the source:unknown recorded in for any authentication logs and i expect it to be source:IP address of the actual source. It is working fine on other switch versions, can any one of you confirm if this is expected and how to fix it?
I have a nexus 5548 that I have recently tried to upgrade the NX-OS on. During the upgrade process, the switch is suppose to reboot itself and load up the new version when it has been installed. However, it has since not been able to do so. I keep ge...
Hi,I am just trying to configure the ethernet interfaces on my Nexus 7010 48 port module. When I do a "show interface" I only see the management interface on the management module and not the 48 port module. When I run a "show hardware" I am able to ...
Hi,I just recently got a 48 port module for our Nexus 7000 series and I was just wondering what the correct installation instructions are. I thought it was merely plug and play but that does not seem to work. When I plug in the module into slot 1, th...
Thank you very much guys. I was not able to add the ethernet ports to vdc1 since the admin vdc was not specified to handle f2 (and could not be set to handle it with limit-resources). Instead, I created another vdc and was able to allocate the interf...
Thanks Steve. That seems to be very close to what I am looking for. We are running 6.1(2) right now but I see that it does not support the "system module-type" command. THat is only in 6.1(3). We are not able to get the upgrade yet due to SmartNet pr...
Subhash, I believe I am using the default vdc on the switch.show run shows: _____________________________________Nexus-7000(config)# show running-config!Command: show running-config!Time: Tue Jul 9 19:21:30 2013version 6.1(2)poweroff xbar 4poweroff ...
Looked in there already. Seemed like the command should just be "interface ethernet 1/1" to configure port 1 on the module in slot 1. However I get an invalid range error and when I run "show interface" I only see the management blade interfaces rath...
