Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been unable to successfully configure the Cisco IOS Embedded Event Manager (EEM) "action mail" command when the "server-address" includes two "@" symbols. The SMTP server that I will be using utilizes the user's email address as the username...
Have the requirement to configure a Call Manager Express to operate with third-party SIP phones. The configuration needs to be configured prior to knowing the MAC address of the third party SIP phones. This would be similar to using the “auto assign”...
Has anyone developed an EEM Scrip to measure telephone traffic on an ISDN PRI interface on a voice gateway? Preferably the traffic measurements would be in Hundred Call Seconds (CCS) or Erlangs. It would appear that the “show isdn service” command c...
I changed the “id mac” associated with a working SIP phone and the phone would not register. When I changed it back to the correct mac address, the phone registered again. The phones are in the same subnet as the router. I did several searches on ...
This is being developed on a lab router operating Cisco Unified Communications Manager Express Version 7.0(1). When I attempted to configure voice-register-pool without an "id" command, I get a "configure voice-register-pool id first" message from t...
