Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI'm trying to setup channel group containing multiply timeslots on 2651XM using ITP IOS.All is well till trying to setup the encapsulation with the following errors shown : ITP2(config)#int se0/0:0ITP2(config-if)#enc mtp2Error in encaps setup. ...
HelloI'd like to ask if it's possible to configure SCTP/M3UA on Cisco 2811 but without any serial kind of interface,only by using one Ethernet port ?According to the document :http://www.cisco.com/en/US/docs/wireless/itp/RNsPDFs/RNSW4.pdf(Caveats CSC...
HelloOne of the most elegant way for start would be to download MIBS for the IOS You're using at the moment,enable 'snmp-server' on Your ITP box,download some graphical snmp monitoring program and see what You get.For a detailed review what You might...
HelloI think the biggiest difference is not of technical but legal issue.Frequency of 2.4 GHz belongs to so called 'ISM' bands ,more at :http://en.wikipedia.org/wiki/2.4_GHzwhile for usage of frequency of 5 GHz You usually should have a licence to us...
HelloThank You for the information. I'm not sure,but it seems that Cisco ITP will not allow You to configure SCTP/M3UA in client mode,only in server mode.When I did configured an example SCTP/M3UA connection,I was able to connect to Cisco with M3UA c...
