Hello
I'm trying to setup channel group containing multiply timeslots on 2651XM using ITP IOS.
All is well till trying to setup the encapsulation with the following errors shown :
ITP2(config)#int se0/0:0
ITP2(config-if)#enc mtp2
Error in encaps setup. Encapsulation not changed.
ITP2(config-if)#
the 'sh run' for controller E1 shows the following :
controller E1 0/0
framing NO-CRC4
channel-group 0 timeslots 1-31
g732 ber
If I configure channel group containing only one timeslots,everything is fine,but as soon as I tried a channel group containing multiply timeslots I got this error regarding the encapsulation.
Any clue perhaps ?
Sincerely
