Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone!!
I have a P2P link between 2 Offices (layer2 link)
3560x------3560x
I need to limit the bandwidth (we pay for 10Mbps), tried the commando below but users are still getting higher speeds
SW-CORE-01#sh run int g0/20Building configurat...
Dears,
Recently our provider changed the type of our P2P Link between our remote office and HQ. THey said we are now connected via L2 WAN Links (P2P)...
But after That our clients in that remote office are not getting IPs anymore (DHCP server is loc...
Dears, Due to VLAN numbers difference, we had to implement flexconnect at remote offices using VLAN mapping parameters...We need to control bandwidth for all mobiles/tablets traffic... How would be the best solution ? Does the WLC have any BW control...
Dears,Does anyone can confirm if bandwidth limitations configuration at WLC 5508 (jpeg attached) should work in remote sites APs (configured as flexconnect)? We configured that parameter but it seems to be working only with our local APs (same office...
Hello All!!I need to create a EEM script to shutdown both "interface VLAN" and interface giga if certain IP address stops to reply pings.... I did that:event manager applet SHUT_INT event ipsla group-name "PING" reaction-type timeout dest-ip-addr 172...
Hello thx for the reply...
but the main problem is... A router is connected to that WAN link, ip helper address is confgured at internal L3 SW (interfaces VLAN)... as per belowL3SW---accesslink--- RT------WAN_L2link-----RT-------DHCPSERVERThis L3 sw...
Hello my friendReally appreciated your help... I checked the documentation... very nice! But now I am looking for a way to control bandwidth consumed by a huge number of mobiles in a remote office...the only way I know would be policing the traffic a...
Tried again this version this morning and that worked.... probably I did some mistake yesterday... Thank you very much.... below my config used ip sla 11 icmp-echo X.X.X.X source-ip X.X.X.Xip sla schedule 11 life forever start-time nowip sla reaction...
Hello,Didnt work... ip sla can monitor successfully, tracking is aware of everything as well... bt for some reason the cli is never changed... it looks like the event manager dosent take any action...I have also did the config below and didnt work as...
