Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Troubleshooting section of SX80 codec GUI says: WARNING: Output Connector LocationsYou have two connected outputs configured with overlapping location. Please update the Location configuration for your video outputs to match physical layout. which li...
Hello, I feel like in the (distant) past there had been certain TMS versions that would work only with certain VCS-C and VCS-E versions. We currently have around 32 endpoints, a mix of SX, C-series, and MXP lines. We are on TMS 14.6.2 and would like ...
Minor annoyance but would love to find a solution.
We frequently access our older MXP codecs (latest FW on them) via the web gui, by putting in the IP address into internet explorer 11. The web UI does not refresh properly or respond well in other...
I somehow stumbled across this other Cisco Community. I am used to posting in THIS one, but I was wondering if there is supposed to be a different audience for the other one? They both seem to be a decent place for endpoint, TMS, and VCS support, ...
Oh! I remember seeing that! We had a touch panel connected to an MXP that was acting up and sometimes it would appear to lock up and not respond but if you had touched it several times, it would spit out all the registered touches on buttons a moment...
It turns out, I've found there's a Windows GPO in effect that causes this:
Network access: Do not allow storage of passwords and credentials for network authentication
located in
Computer Configuration\Windows Settings\Security Settings\Local Polic...
Hello, Wayne!We are running TMS 14.6.2.The Scheduled calls are set to dial automatically and auto-answer.The time servers are all local and current for all codecs and TMS.
