Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I understand that Meraki Switch cannot configure for PVST or MST, and if we need to connect Meraki SW to 3rd party switches which run PVST/PVST+ or MVST, Meraki BPDU traffics will go through only VLAN1. In the environment where we mix Meraki switches...
How does MX report its RTT Latency and Jitter report in MX Summary (Organization > Summary Report)Does MX measures RTT, Latency based on real traffic which goes through each WAN ?or it measures against the IP destination that we configure in SD-WAN &...
In the Meraki Mesh document (as of Oct 3,2023 update), it said that the New Mesh Features in MR 29.1+ Firmware supports AP Mesh over 6GHz on new Wifi6E AP (for example MR57).I understand If we use 6GHz for Mesh backhaul, that means we free up 2.4GHz ...
My client is a supplier for a large US automaker. The automaker requires every suppliers to crate a S2S VPN for its auto sequencing process. Currently my client uses Cisco ASA, and the setup goes like this.Now, I am replacing the ASA5505 with Meraki ...
Hi there,
I am trying to setup Duo 2FA to protect my legacy web servers. I have created Duo Network Gateway successfully (on CentOS), and I am in step3 “Add Web Application”.
Duo NG instructs me to “Add a new Duo Network Gateway - Web Application” i...
I thought I have to go with option a) ?because BPDUs are sent untagged and Meraki said " for Meraki switches to participate in a spanning tree topology with PVST/PVST+ protocols, a spanning tree instance must be running on VLAN 1 of all switches"
Am I right to say that"non-Meraki PVST/PVST,MST (including Meraki MS390), send BPDUs on every VLANs. However, Meraki switches (except MS390) will only participate BDPU with those non-Meraki switches on its VLAN 1 Native VLAN" and Meraki Management V...
Thanks JeroenVercoulen for good source of document. Yes, the document stated that MS390 Specific GuidanceIt's required to have the same native VLAN configured for all switches in a STP domain as a switch will only send (or listen to) backward compati...
Thanks IvanJukic,Many company's practice is to avoid using VLAN1 for its native vlan. But when we need mix Meraki switches with PVST/PVST+/MST non-Meraki switches, our Meraki switches have to use VLAN1. So in this case, I think my question is should ...
