Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello every one ,I have an autonomous AP cisco model 2602i .What I want ask is this model support layer 3 ,like command ip route ,router rip,router BGP ,etc?thanks,Ridho
Hi everyone ,I have DMP 4310G with 5.4 firmware version.and DMMVM 5.4.what I want to ask is, how to rotate content in DMP 4310G and DMMVM 5.4 ?because I check menu webgui in DMP 4310G with firmware 5.4 or DMD and I cant find setting to rotate browser...
Hello everyone,Can I Installing DMS-5.2.0.25 in UCS-C24-M3 ??because , after I insert CD and boot it . I found a warning message."system detected unknown". Thanks for your help.
Owh , I tried to delete " ip routing" command in my Access point and finaly there isn't routing command anymore.hmm but , why is ip routing command can be applied to my Autonomous AP?thanks for advice,Ridho
hi Abdullah,Thank you for your reply .So I can't use routing command in AP but, can you look my attachment configure about my Autonomous AP ?wow.. I can input route command in my Autonomous AP 2602i"ip route 0.0.0.0 0.0.0.0 10.7.0.1"without ip rout...
Dear Thomas ,Thanks for your help.hmm ,about this command ...https://:7777/set_param?init.ROTATE=90&mib.save=1is this command can be saved in DMP configuration after I reboot or accidentally power failure on DMP ?Thanks and regrads,Ridho
so, i must change my equipment to support my dmmvm version 5.2 like MCS or UCS-C220-M3, UCS-C210-M2 or UCS-C200-M1.ok ,thanks for your reply..Regards,Ridho
