Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i want to send an email on a successful login on a nexus 9k.
therfore i have this applet:
event manager applet login
event syslog pattern "AUTHPRIV-5-SYSTEM_MSG"
action 1.0 cli show users
action 2.0 cli callhome send eem subject "login" body "$...
Hi,
I have two ASAs in active/passive failover mode behind a pair of two ASR1001 edge router.
Therefore both ASAs need a link to both routers and in case of failover the IP moves to
the standby box. So to establish OSPF neighborship it needs on both ...
Hi,I have some 7841 IP Phones which authenticate over 802.1X (EAP-TLS with the Manufactured Installed Certificate with FreeRadius).Now we bought some additional ones which do not work with the same config.I realized that the "old" ones have V03 at th...
Hello,I have a ASR1001 running IOS XE 03.08.01S. I get a default route for IPv4/v6 over BGP whichis redistributed into OSPF for v4 and ISIS for v6.Now I've upgraded to 03.13.02S and the default IPv6 route is not redistributed into ISIS anymore.If I g...
Hi Mohammed,I guess the new phones have other root certificates?I have trusted the Cisco Root CA and the Cisco Manufaturing CA which seems enough for the old phones. I found some hints that there are also a CAP-RTP-001 and a CAP-RTP-002 certificate t...
Jon thanks for the response!no passive-interface for the new subinterace was missing in the router config.Sorry for that stupid mistake...Kind regards, Chris
