Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
WARM Spare Question:i will have two different isp with different WAN IP from different subnets. can i configure two mx in warm spare to two different ISP with different WAN IPs without VIPconfiguration.Azure MX Question:i will install 1xvMX in each U...
hi,
I have test setup in the lab. 2 core (C9500-32C), 2 disti (C9606R) and 2 leaf switchesc(C9300X-48HXN stack). i am testing TRM on one VLAN within vrf, all with 17.15.03 firmware.
ubuntu is test mcast server while clients are ubuntu and cisco test ...
hi,
I am in the process of testing BGP EVPN. requirement is to allow multicast between vrf. for this reason third party firewall loopback interface is configured as multicast RP and SPINE is configured with border role to provide L3 external connecti...
I have integrated Cisco SDWAN with umbrella, when i run show sdwan umbrella device-registration. i can see following
#show sdwan umbrella device-registrationNAME STATUS TAG DEVICE ID DESCRIPTION--------------------------------------------------------...
hi
i have configured Umbrella Secret and key for Umbrella dns integration. DIA is configured for this VPN. i am not able to see SDWAN router on umbrella portal.
on c-edge (router 8200 v17.09.03a)
sh sdwan umbrella device-registration DEVICE
NAME STAT...
thanks. vMX with Azure vWAN is example of single region vMX. but my setup would be regional and failover hubs. so for UK based traffic link between UK vMX and Azure vWAN is preferred and for India based traffic link between India vMX and Azure vWAN i...
hi,
because its anycast rp configuration for TRM, i am not sure whether msdp is required for anycast rp like underlay multicast routing for BUM traffic or not.
hi,
my bad, i mis typed command when I posted here, on multicast receiver leaf you can see the join request using 239.1.1.203.
leaf1:
(*, 239.1.1.203), 20:50:52/00:02:01, RP 10.2.255.255, flags: SJC
Incoming interface: Null, RPF nbr 0.0.0.0
Outgo...
hi,
thanks for your reply. my first concern is whether this is a valid design. in cisco guides, i can see Spine can be configured as border device to provide layer 3 external connectivity but i am not sure whether multicast will work over this layer ...
Actually, key and secret were wrong. after correct key and secret, i faced umbrella dns certificate expiry issue, which was resolved by following link.
https://www.cisco.com/c/en/us/support/docs/field-notices/741/fn74166.html
this time when i do show...