Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
Can you please share the CLI/GUI command to check snort version on Firepower device 7000/8000 series.
Also the recent list of commands which is used for Cisco Firepower 7000/8000 series
Current version of FMC is 6.4.0.13.
Thanks in advance
...
Good Day Experts,We have an issue with our FMC, it gives an error when logging in to GUI despite no changes made We are unable to login in Sensor GUI and getting below error but able to login in Sensor CLI.error 500: internal server error Product FP7...
Good Day During our internal scan of the Cisco APIC, we have identified the existing APIC is running deprecated SSH Cryptographic Settings. I checked the existing management profile for the APIC and there is no option to disable deprecated SSH settin...
Good Day We are planning an upgrade of the IMC Cisco Firepower Management centre.Can we upgrade the cisco IMC 2.0(13e) directly to 4.1(f) or any intermediate version? is any guide available with the steps to reimage the Cisco FMC through Cisco IMC C...
Good Day, Problem Description: IP prefix lists are still being shown when using the “sh IP prefix” command despite being deleted and not in use by any route map We have created new prefix list to replace old ones, however old prefix list still presen...
@Georg Pauwen @Harold Ritter Thank you very much for the affirmation and for the information provided. I will definitely take a deeper look into this Thanks once again
