Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I have configured radius for dot1x in an ACS 5.2. When I tried to connect a user to a dot1x enabled switch port, I get the following error in the radius. DescriptionIdentity policy result is configured for password based authentication methods ...
HelloI have a vpn setup which is working on a Pix 535 firewall. I have more then 100 VPN accounts but my problem is that the vpn users are getting ip address from a common pool and i do not have control on the IP address. I want to configure the syst...
HelloI want to understand where we can use the below mentioned commands.no boot network and no ip idented.I am trying on multiple platforms/hardwares like 6500, 4900 , 3700 and 7600 but it is working on 6500 and 7600 only. Are these commands platfo...
Hi Experts,We have a server connected on 1Gig port with a traffic load of 900mb tx and 900mb rx. For business requirement we need to span rx and tx traffic to a destination of 1gig interface on same switch. Since total traffic is more than 1Gb, it is...
what if the word used in the dictionary, and still mail are blocked due to reading half word from the mail body. Example:Word in the dictionary is : ASS in the mail word used is Assembly How can we stop this
Cisco Team,I have facing HULC LED process cpu high utilization on Cisco 3560 deviceKindly see this issue Coz We have a lot of 3560 devices . CPU utilization for five seconds: 45%/27%; one minute: 77%; five minutes: 81% PID Runtime(ms) Invoked ...
Hi Tushar,Can you please also let me know how to resolve issue of dot1x connectivity, when a user who has connected his laptop to a dot1x enabled port and the laptop is yet to boot.Rgds,Abhishek
Thanks Tushar! Its working flawlessly now. Able to authenticate user on certificate base. Lesson learnt: Always use IE for Cisco ACS GUI. Regards,Abhishek
The issue was with the firefox...not able to check the setting in it, properly. Making the changes through IE. Will revert back with the status.Rgds,Abhishek
