Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've the above message on a 2811 with a vwic2-1mft-t1/e1 . The alarm led also goes on. No cable connected but show controller E1 shows as follow. E1 0/0/0 is down. Applique type is Channelized E1 - balanced Transmitter is sending remote alarm. Rec...
I'm configuring a ASA to authenticate against the RSA using it's build in Radius server. I'm testing using "test aaa-server authentication RSA-Radius host 172.18.248.223 username testcisco password test1234123456"I assumed password "test1234123456" c...
Have anybody done a DMVPN using static routes instead of using EIGRP or OSPF ? I'm trying to explore the idea to see if I can work around the Single DMVPN using dual hub. Thanks.Please post your experiences if any. Thanks.
Hi Nick, I guessed as much but was just hoping someone would have a alternative solution. I've tried a couple of other routers with the same result, so I guess that rules out reseating or slot issues. I'll get another replacement card. THANKS.
You need to at a minimum create an ACL to prevent H323 traffic that originate from the internet from going into your gateway and only allow those from your sites.
Thanks. There don't seems to be a option to view your email address. Maybe it's not published. Mine is in the profile. Please drop me a email. Would like to bounce some Qs off you. Thanks.
1. I'm using AuthMan 6.1 . 2. Could you give a example ? I'm assuming a standard Radius config on the ASA. aaa-server RSA-Radius protocol radiusaaa-server RSA-Radius host 10.1.1.1 key abc123 authentication-port 1812 accounting-port 18133. I'll try th...
