About Umesh Shetty

Umesh Shetty · 04-10-2024

Hi TeamI am trying to lookup the YANG model in XML format and get this error. Do you know what I am missing here ?ushetty@sm-vlab1:~/yang/vendor/cisco/xe/1781$pyang -f sample-xml-skeleton --sample-xml-skeleton-doctype=config Cisco-IOS-XE-switch.yangC...

Umesh Shetty · 10-21-2021

hi Fellows I am fairly new to using YangSuite and Netconf. I have a basic requirement to shut/un shut an interface on a switch. I installed YangSuite and am using the the edit-config functionality on the ietf-interfaces YANG module. I simply add the ...

Umesh Shetty · 09-20-2021

I am using YangSuite and am able to send RPC requests to my target device and get response etc. I wanted to know if YangSuite has a tool inside it that can convert an RPC into Python code for me that I can use ? I remember seeing it in another syst...

Umesh Shetty · 02-26-2019

Hi Team, I am new to using Netconf and need some help or startup guide. I am using ncclient Python library to connect to the netconf switches. I was able to do the initial connections and also fetch some config data for example using the below xml pa...

Umesh Shetty · 06-26-2018

Guys, Been a long time but back with a hope of getting some help as usual. I have a CloudGenix SDWAN device connected to a WS-C4507R+E switch. The CloudGenix has a Controller port which connect to a switchport on the 4500 , port is configured as an...

Umesh Shetty · 04-12-2024

Thanks @DrSchw0b , I have a folder structure cloned from GIT Yang repo and my module depends on the ietf-native but also a couple others. Should I be listing all the dependent modules ?

Umesh Shetty · 04-10-2024

@DrSchw0b where did you get the /native/ntp from as the path ?

Umesh Shetty · 05-08-2022

Lets try to do this via an example and lets to scale to 16 million for now I will try to explain how VLAN's are insignificant across a fabric and how VNI's take over the entire fabric and VLAN's are local to a Leaf/Switch Assume a fabric that has 100...

Umesh Shetty · 03-24-2022

Kailash, 100 mbps is too high with NAT enabled for the 1841 to handle. You should go for a bigger router. In case you need some guidance on router selection please do reach out

Umesh Shetty · 03-24-2022

I think it is disrespectful to laugh out at a question. It is obvious that the person does not know the right way and he has reached out to the community to help

Member Since	‎02-22-2013 11:26 AM
Date Last Visited	‎04-17-2024 12:04 AM
Posts	160
Total Helpful Votes Received	83

User Statistics

User Activity

Yang Model Lookup

Netconf Error <bad-element>type</bad-element>- Yangsuite

Python Code from YangSuite

Netconf XML payload

WS-C4507R+E Dropping UDP/3784 Malformed Packets

Re: Module Error with pyang sample-xml-skeleton and IOS-XE YANG models

Re: Module Error with pyang sample-xml-skeleton and IOS-XE YANG models

Re: VxLAN VNI to VLAN Mapping

Re: cisco 1841 cpu high utilization and disconnect from network

Re: cisco 1841 cpu high utilization and disconnect from network