Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've recently upgraded a stacked pair of WS-C3850-12XS switches to version 03.07.05E. Following the upgrade, the primary switch in the stack no longer recognises the SFP's connected in ports 1/0/1 & 1/0/6. The secondary device has SFP's connected in ...
HiI need to move our UCM Publisher to another IP Subnet as part of a data centre migration. I'm comfortable with the procedure to update the address, however, we also use UCCX 7.0(1) and I'm not sure what (if anything) I'll need to do on the UCCX ser...
After trying to downgrade a Nexus 7K from 5.2.1 to 5.1.5 by updating the boot & kickstart boot statements and reloading, I'm now stuck in an endless cycle of reloading. See below:Is there a break sequence which will allow me to modify the boot state...
Is it possible to update the publishers IP address on a subscriber without using the web GUI and OS Administration tool?I've changed the IP of the publisher in my lab but the subscriber still has the old details when I run a "show tech network hosts"...
Actually, there is no SFP installed in 2/0/6. (My mistake)
As I mentioned previously, I know the SFP's are inserted properly into ports 1/0/1 & 1/0/6, as they were recognised before the sw upgrade.
What is strange is that switch one still recognises...
Unfortunately the device is located in a remote DC, so I will need to arrange access before I can complete any L1 troubleshooting.
Here are the details requested:
1. SFP-H10GB-CU5M (Te1/0/1) & SFP-10G-SR (Te1/0/6)
2. Switch Ports Model SW Version SW ...
I have an almost identical issue. The only differences are that I'm using WS-X45-SUP7-E, and IOS 03.04.01. However, the condition of the fault is exactly the same.James
Hi JamesFunnily enough we've only just rectified this issue after discovering it nearly two years ago.The problem we had was to do with the default size of the SP & RP RAM installed on our Sups. Basically, because the kit was purchased before May 200...
