Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had an AP that wouldn't join its primary controller. When I looked at the logs on the controller I saw this message. %LWAPP-3-LICENSE_ACQUIRE_ERR: spam_lrad.c:407 Failed to acquire license from the licensing module, maximum APs Joined 300/300. Thi...
Is there a guide or any documentation regarding hosting a 5508 or any physical WLC in a colo? The Management IP and VLAN ID will change. All of the APs connection to it will be in Flex Connect mode. Do I need to worry about changing the IPs on the ...
Is there a way to use Cisco Prime Infrastructure to convert an LWAPP(s) to autonomous mode? I need to convert 30 APs back to autonomous mode before we sell a site.
This is terrible. I had a 5508 WLC that I couldn't access remotely but Prime reported that it was still serving APs. TAC RMA'ed it. Got the replacement, upgraded the code and I could access the GUI. I restored the config from a backup and guess wh...
I have a 2 member interface group associated to a WLAN, interface 1 and interface 2. I know the controller round-robins clients between the interfaces in the group when they connect to the WLAN. If the controller assigns a client to interface 1 and...
Do I just delete each member from all of the controllers and re-add them? Is there something else I need to do?@Scott Fella wrote:You have to reconfigure the mobility group setting since the up address will change. This is not a big deal.
