Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We accidently lost ios for 2960-x switch and i tried to upload new one via xmodem rommon mode. I copied new ios from other switch and also download from cisco website but in both the caseafter "boot flash:image.bin" command it ends with follwo...
Hello,I am facing this from ong time.Please check attached file for reference.I am pinging from local machine to access switch where i am getting ping reply more that 1ms.Then to second hop also i am getting some delay.i have also check traffic on al...
Hello,I am working on following topology in gns3. When i try to traceroute from r3 to r5 i am getting following resultR3#traceroute 192.168.1.50Type escape sequence to abort.Tracing the route to 192.168.1.501 192.168.1.50 16 msec * 8 m...
Hello Richard,
Thanks a lot. The issue has been resolved already by CISCO NOC while uploading compatible image.
This issue is known issue at cisco (A BUG) for 2960-x models. Cisco tried to upload same image that we lost before but still getting same...
Jon,He must again confirmed his requirement before any suggestion, If what he reply to my post then i have to alter last nat statement as follows because in section -2 static nat order first and then dynamic.object network LAN subnet 192.168.1.0 255....
Jon,I was wrong for section-2, yes we cant change order no st section2. Actually during config it will allow u to set line number but after config that statement exists section 2 and entered into section1,i just tried on test lab Thanks,
1. Yes we can change order nos in section2.
2. for ssh - u r right it will use ip of 12.34.56.5 i configure it as per what he needs,
12.34.56.5 Any 192.168.1.* IP not mentioned above - Mention ip is ip for outside interface vlan 2
interface Vla...
