Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to know the command for setting the power levels on the switch ports of a 2960 Catalyst POE switch. It is running Version 12.2(55)SE5 IOS. Thanks, Dennis
I have a 24 port 2960-S that is not communicating with a 2960-LST that it is directly connected to over fiber. The link is up on the LST but will not come up on the -S. What command should I use to bring up this link? I have tried no shut from the...
I am trying to convert two Aironet 1141n access points to autonomous stand-alone units. I have connected the console cable and I can see the unit giving information in the console window, but I cannot type any commands. When I try to get the unit t...
Thanks guys, I think I have it now. When I do a #show power inline, all the ports say auto. When I plug something in and the port light goes green and I do a #show power inline, it will read auto on all ports except the one where it has something ...
Okay. Problem solved...sort of. I still cannot type any commands in through the console connection. BUT, I noticed that the tftp server was 32 bit and my system is 64 bit. I changed servers, connected an AP and VIOLA! IT FREAKIN' WORKS! Okay, ...
Scott, they are NOT autonomous. I want to convert them to autonomous. This is what I am havving problems with. I cannot enter commands, and I do not know if that is from the aps being lightweight or some problem with my connection. Yes, I am cons...
Scott, I cannot enter any commands. I can see the output from the ap on the console window. But I cannot type anything when I try. What would cause this?
