Hi When trying to add AP to controller I'm reviewing the following log as the AP is not able to join the controller Below is the results I get with the newer WAPS  *Mar  1 00:00:13.011: APAVC: Initial WLAN Buffers Given to System is  2500 *Mar  1 0...

Hi We're having "CISCO2921/K9" device which is configured with NAT overload with one external internal : ip nat inside source list 1 interface GigabitEthernet0/0 overload But this kind of configuration is not very useful to us because every day we...

Is it possible to find the AP's location by radio? I mean, we've many APs installed in the company buildings , but do not have the information where they are installed . Is it possible to find there location by Prime ? (we've all the buildings maps a...

Version 12.2(44)SE5"WS-C2960G-24TC-L" interface GigabitEthernet0/6 switchport access vlan 91 switchport mode access switchport voice vlan 93 switchport port-security maximum 2 switchport port-security switchport port-security aging time 10 storm-co...

we have two cisco routers , one is 1941 and 1841 they're both connecte dto BB switch yesterday we disconnected LAN interface Gi0/1 on the active router (1941) and there was no failover . please advise why failover didn't happened here is my config: ...