Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After creating guest user credentials via Cisco Prime Lobby Ambassador, you receive a summary page(attached) that list the start time and end time. The issue is that the times show up in UTC instead of GMT, does anyone know how to change this? Than...
After creating guest user credentials via Cisco Prime Lobby Ambassador, you receive a summary page(attached) that list the start time and end time. The issue is that the times show up in UTC instead of GMT, does anyone know how to change this? PI v...
I know the WiSM 2 is like the 5500 WLC regarding the fact that you do not need to configure an ap-manager interface for CAPWAP packets because by default the managment interface acts like an ap-manager interface.What is best practices? Any major adv...
I think I already know the answer, but I cannot find any solid documentation. Does the WiSM2 support the 1231G AP, if so can anyone provide documentation?Thanks.
You could just power down the wisms on the 6500 during the wism2 upgrade.No power enable module (#)Once the upgrade is complete, power them back up.Sent from Cisco Technical Support iPhone App
It refers to the 2.4GHz and 5GHz frequencies. 802.11b and g utilize the 2.4GHz band, while 802.11a uses the 5GHz band. 802.11n uses both. The differences between a,b,g, and n are supported data rates and modulation schemes.Sent from Cisco Technical S...
We found that this message was received whenever one of our APs could hear a rogue AP that had a hidden SSID.Sent from Cisco Technical Support iPhone App
