Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I using Cisco VPN Client 3.0.4. I have a good tunnel established and can connect and browse,connect, telnet to anything on my network fine. So, I believe I have my routing, natting etc correct. I however am not able to telnet to the router that my tu...
Is there a local file on the 3005 that keeps track of connections. Mgmt doesnt want to spring for a syslog server, we are a small shop. I can find the event log, but it only holds 256 events nd we get an event ever few minutes. Thanks
Anyone know of a way that one can telnet to the same pix that the vpn tunnel is established on. The telnet(interface) x.x.x.x command asks for an interface and address. My vpn pool addresses reside on the pix not out an interface.Thanks
Hi, We recently had to re-install VMS due to a corrupt database. We actually fdisked the hard drive reinstalled Ios with the appropriate patches and reinstalled VMS. Everything has been smooth until I try to upgrade the signatures on my sensors. All ...
I have the same problem, have you recently upgraded VMS. I'm trying to find something commom. We recently had to rebuild our VMS server and software, which went smoothly until I try to upgrade the signatures on the sensor. Upgradew were fine until th...
Thank you for you assistance. I tried all but to no avail. I finally reimaged(IDSMk9-a-3.0-1-S4-5.xxx) the IDSM blade via ftp and applied the 3.0(6) S42 sp update via ftp and I am now able to telnet into the sensor blade.
