HI, i have a nexus 5596 where the SIV will not come up. Some logs are as below. Any help will be appreciated. Rgrds,Philip. sh ip int brIP Interface Status for VRF "default"(1)Interface IP Address Interface StatusVlan175 ...
Hi, I am facing an issue with my AP not joining the controller. Following is the error log Mar 1 00:01:11.923: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER*Mar 1 00:01:21.923: %CAPWAP-3-ERRORLOG: Go join a capwap controller *Apr 3...
Dears,I have a specific requirement from a client as followsThe client has a branch office and HQ connected over an MPLS cloud. Internet access is provided through the HQ only.They want to provide guest internet in the branch and want to terminate t...
Hi Guys,Just wanted to confirm if the above AP and antenna are compatible.I was trying to configure them on the Cisco configurator, but I couldnt find it as an option for the 1262AP.Any help would be highly appreciated.Rgrds,Philip.
Hi Folks,I am facing a strange issue with a Wireless Bridge Setup which i configured 3 days ago. Everything was working normal for a couple of days until yesterday when the setup stopped working.On check what happened, this is what i was able to find...
Hi Tilak, I have created the L2 VLAN. The outputs as follows NXSRAGG02# sh interface vlan 175Vlan175 is down, line protocol is down Hardware is EtherSVI, address is 002a.6a9c.2441 Internet Address is 10.9.175.5/24 MTU 1500 bytes, BW 1000000 Kbit,...
Hi Leo, The controller was connected to Line Card 1. I connected to another line card and it started working fine. The AP registered. When i put the controller back to the old line card, it stopped working again. That is how i confirmed that it is th...
Hi Guys, Thanks for your inputs. I investigated the issue suspecting a problem with the communication between the WLC and the APs. Actually the WLC is connected to 2 6506 chassis with the 1st chassis as the root.I discovered a minor error on the modu...
Dears,Luckily everything worked as to plan.The client already had an existing controller in the HQ, So i created a WLAN anchoring to the HQ WLC. and then to the firewall direct.Cisco doesnt recommend using the anchor controller to manage APs, however...