About Luke Sykes

Luke Sykes · 03-18-2016

Hi There Is there an order to reboot the clustering conductors - master then slave etc Kind Regards ...

Luke Sykes · 03-18-2016

Hi There If one of two clustered conductors is lost on the network, the client has to manually inter...

Luke Sykes · 03-03-2016

Good Morning One of my clients us currently having issues sharing content with on particular endpoin...

Luke Sykes · 02-29-2016

The test call I did with the client was from our MCU 4505 via our ISDN GW. The VC EP is a Cisco C40....

Luke Sykes · 12-17-2015

Hi Shea Thank you for your help. I will get the client to do that also. Many thanks Luke

Luke Sykes · 12-17-2015

Thank you. I will get the client to tuen the lights off in the room rather than moving it first of a...

Luke Sykes · 12-16-2015

Hi Shea Thank you for your response. We have already looked at Kiosk mode as I mentioned in my post....

Luke Sykes · 11-16-2015

Ok, Thank you for your reply I wondered if it was in the serial number perhaps. Like how the 6000MXP...

Luke Sykes · 11-16-2015

Hi All How can you tell if a C60 is a Gen 1 or Gen 2 without looking at the physical device. Many th...

Luke Sykes · 08-20-2015

Hi There I have searched high and low for an answer on this including our own configuration but i ju...

Luke Sykes · 07-31-2015

Hi PatrickThank you for your replyI have since discovered that the client was using a splitter to se...

Luke Sykes · 07-30-2015

Hi AllI have a client who just upgraded their C40 from 7.1.1 to 7.3.3 and now he cannot share PC whi...

Luke Sykes · 07-30-2015

Hi AllI have a client who just upgraded their C40 from 7.1.1 to 7.3.3 and now he cannot share PC whi...

Luke Sykes · 04-29-2015

Try entering this commandxConfiguration Peripherals Profile TouchPanels: 0This configuration sets ho...

Luke Sykes · 04-22-2015

Good afternoonI hope someone can helpOne of my clients has asked me if a VideoConferencing endpoint ...

Is there an order to reboot the clustering conductors - master then slave