Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our datacenter employs many Catalyst switches and so far we have used Cisco Network Assistant in order to manage them.Out latest addition has been 2x SG200-28 switches, however I can't get the SG's to work with latest CNA 6.2, even though they are su...
Symptom: Incoming call, one ring, dead air. Hang-up, call again, one ring, AA answers. This pattern repeats over and over.From term mon I see both calls answered. (Interface BRI0/1/0:2 is now connected to 398 N/A).Please advise.
I have a UC560 which generates tremendous traffic in our LAN. Switches go like crazy like they receive a huge load of broadcasts. When I disconnect it from the network all switches go back to normal operation. Is there any way to find out what genera...
Good day,I have a UC560 installation with the following two issues:1. Regarding the IVR, I have a random behaviour of no response described as follows: The incoming call is received (I see it in the terminal monitor) but the IVR does not respond. It ...
Hi to everyone,Could someone tell me please if the FAC - Feature Codes works for analog phones? When I try to use **4 or **5 the phone gives me busy tone.UC560 - SPA8000 I've connected analog phones to SPA8000 and registered them via CLI. This is my ...
Finally we've solved it!
The device's password included the character "#", which is not supported on CNA! After we removed the character off the password, it connected immediately
Anyway, thank you very much for your recommendations.
I hope this po...
Can I ask you which firmware version you are using on your SGs?
are you use some customized SSL certificate on switch?
No, I haven't configured anything related to the SSL certificate.
if so, could you try to use self-signed certificate gen...
I have tried this already, no luck... I found a post about the same issue about 1 year ago with SG300 and CNA, but was fixed with a firmware upgrade.That's weird, I already flashed the latest firmware (1.4.1.3 at this time) and I still get the error ...
