Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a working ACL. It is applied inbound on the switch port with a server attached. However, the logic is confusing me, as if I switch src/dest around, it no longer works.
Setup:
3650 Switch, server on port g1/0/7. Switch trunked to a pair of 9k...
Hello,
I have never setup an ASA in an environment with a single public IPA. So when I needed to NAT different ports to different internal hosts, I had to do some research. Found plenty of good examples, but I am still having some bad luck making it...
Hello, we recently turned up a 100mb circuit between sites, and it is leaving a 1gb interface.WIth my current QoS setup, I have set the serial bandwith to ~45mb and set my policy map to total less than that. I have the max-reserved-bandwidth set to 9...
I swear during our initial install I could put a user in multiple groups, but now the option is simply not there in my WIndows Jabber client.Is this possible?For history..I am trying to come up with a solution to replace a no longer updated product f...
NP!
Here is the show nat:
Manual NAT Policies (Section 1)1 (inside) to (outside) source static nas01 interface service teamspeak teamspeak translate_hits = 5, untranslate_hits = 142 (inside) to (outside) source static nas01 interface service plex pl...
WIthout the Global allows (still allowed in OUTSIDE), non-working then working entries:
asa# packet-tracer input outside tcp 55.44.33.43 12345 ExternalIP 8082
Phase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit RuleAdditional Information:MA...
