Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Anyone experience with the following messages when power on the virtual machine where PI is installed on:Cannot setup NMI watchdog on CPU 0Cannot setup NMI watchdog on CPU 1Cannot setup NMI watchdog on CPU 2Cannot setup NMI watchdog on CPU 3Thi...
Hello all,When I change an IP address of an access-point with NCS, then the radios are disabled.Configuring directly on the controller keeps the radios on.Cisco Prime NCS Version : 1.1.1.24WLC 5508 Version 7.0.240.0AIR-CAP3502E-E-K9Does anyone recog...
Hello Scott,Changing the IP address from the WLC using the GUI or CLI is no problem, the radios keep up.I also prefer CLI above GUI, but NCS is for persons who are not familair with CLI.And as I earlier mentioned, I recall that with another version ...
Hello Amjed,These are the steps I follow:In the search field in de right upper corner I fill in the name of the access-point.Then I get a pop up, there I click on the link "view list" of the column configuration.I choose the access-point and after c...
Hi Roger,Important things to know is the distance between the two buildings, obstacles and other possible interference.Here is a link about antennas from Ciscohttp://www.cisco.com/en/US/prod/collateral/wireless/ps7183/ps469/product_data_sheet09186a00...
Hi,You don't need an IP helper address on the switch.A IP phone send out a dhcp discover on de DATA vlan first.So you have to move the vlan option, in your case option 191, to the DATA scope. The IP phone will see this option when it get's an IP addr...
Hello,Can you provide the following commandsshow switch virtualshow switch virtual dual-active sumand the configuration lines of the running config forswitch virtual domainKind regards,Michel
