Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Today we are having two CSMs in failover mode and running as follows.Sup2 IOS : 12.2(18)SXF17aCSM OS : 4.2(14)If we put the command (hw-module csm # config-sync) on msfc of active CSM to sync the configuraion between active/standby CSM, standby CSM...
All,We'll set up the ace for SIP and I need to modify the SIP header. There is VIA field included IP address of nodes in SIP header. But actually we don't need this information (except to end source IP address).That's why we want to delelete the VIA ...
All,I experinced critical problem for our customer service pertaing to communication fail for FT between FWSMs.I can just find the log in FWSM as follows and can't find any physical log as interface down in C6500 at that moment.Now our FWSM OS versio...
Hi, Andy,Your solution is very good idea for the selective Q-in-Q unsupported platformI've known that N7K also don't support the selective Q-in-Q until now.If so, is also the selective Q-in-Q available in N7K as your statement ?Thanks in advance,- Su...
We found the fixed IOS version about this issue through the test. After downgrading to the 12.2(18)SXF16 versoin, auto-sync operation works well.Thanks,Sungmin
KS,First of all, thank you for your reply.The followinfg is mac-address-table at that time the problem occured.* 903 001a.6c3d.9200 dynamic Yes 0 Po273* 1127 001a.6c3d.9200 dynamic Yes 0 Po273* 1121 001a.6c3d.9200 dy...
