Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 point to point T1's going from my data center to a larger branch office. At the data center, they are on a multi-channel DS3 on a 7204vxr. At the branch office, I have a 2620 with 2 T1 WIC's. We recently upgraded our internet connection t...
I have a PIX-515UR with 6 ethernet interfaces as my production firewall. I also have a PIX-515R with 3 ethernet interfaces as a backup unit. We copied the config from the production PIX to install on the backup PIX. I had to remove the lines that ...
I downloaded the S167 updates for both the IDS sensors and the IDS Event Viewer. When I tried to install the IDS Event Viewer software, it errored out indicating that I needed to be an Administrator on my PC to install it. I tried to install it usi...
We have a VPN3005 that is using the internal database for user accounts. We would like to move to a RADIUS server, and we are a Novell shop. We have installed the RADIUS service on a Novell server, and it seems to connect as we can see in the RADIU...
I am preparing a 7204 router for a test and when I log into it the promtp says:Router(boot)>Then when I go into enable mode it's:Router(boot)#I have a 7204VXR with a NPE-300, a FastEthernet I/O controller, and a Multi-Channel DS3 port adapter.
That seems to have worked - in one direction. Traffic from the data center to the remote site seems to be using both of the T1's. However, traffic from the remote site to the data center still seems to be alternating. I am attaching 3 files. One ...
Thanks. I do have a slight issue with load balancing. The way it's set up now, a conversation only uses one of the T1's. At night, we are doing a backup, and it is only using 1 of the T1's instead of both. So it is not finishing. I have the stat...
You are correct. After posting my original message, I noticed that the PCMCIA card wasn't fully seated. I looked fine, but when I tried to locate the IOS, I got a reply that the disk wasn't available. I checked the PC card and it pushed in about a...
We had a similar situation where I work. We switched to a Point to Point T1 for every location. We installed a DS3 into our Data Center (channelized, it carries 28 T1's) and it seems much better than Frame Relay. I spoke with someone at SBC (our c...
