Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hiI've been asked to see if we can virtualise our existing asa, it is used just to terminate our Anyconnect clients.From the reading, i can see i should be able to do 750 vpn sessions, if i have 4 vCPU license, and a Premium AnyConnect license for th...
hi i have to create a site to site vpn for an ASA to a C3945 (15.2) router. I'm used to site to site vpns, just not the VRF part.I'm configuring a sub-interface on the 3945 that is part of a vrf.I'm just checking my config is going in the correct dir...
hiI'm making some major changes to the config on an active/standby asa this evening and am planning the roll back in case things go bad.I'm planning to wr mem the config and then 'no failover' on the Active asaTHen make the changes.If all goes well, ...
hi i'm looking to limit bandwidth in and out of a port on a 3750X to 40Mb.Just wondering what is the best practice , i've found a couple of solutions that i think should work, but am open to offers interface g1/0/1speed 100srr-queue bandwidth limit 4...
hi i was just asking if it is possible to create a L3 etherchannel between 2 single 3750 switches that act as our core, (running HSRP for the vlan and with a port-channel between the two) and a new switch stack of 3750s that will be routed to and man...
This is a router on a stick config that goes straight to a checkpoint fw, that is doing the nat, so i'm not completely sure if that makes it the inbound or outgoing i/f.I'll probably implement it in a couple of weeks time and test.Really appreciate t...
hithanks for the respones.i'm terminating the tunnel on the GigabitEthernet0/0.12, which is in a vrf. This interface has a NAT on the firewall to a public IP for the peer address.The customer will then route to other networks within the global route ...
hi Juliothanks for that. All the changes went well, so no need to roll back in the end.I did on the primary/active : conf t, no failoveri then did a show failover on each, i then made some changes, and they weren't replicated to the secondary/standby...
