Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,According to the supported devices list the Cisco Catalyst 3560X-24T-L should be supported by CM by devices update 10. We installed device updates 11 but in CM all our 3650x switches are showing as ciscoProducts.1228. My guess is that's why our us...
Hi,We have LMS3.1 with CM 5.1.4 installed. Somehow user tracking is working for just 2 switches. From all other switches there are no UT records. I guess this is some configuration issue but I don't know where to start troubleshooting. Can someone po...
Hi,We are running HUM 1.1. We run a daily report on interface utilization, at the end of the week we run the same repert but for the whole week. When I check the max values, the max values per day are much higher then the max values per week. How is ...
Hi,We are sending our syslog messages to a central syslog server. However when there is a problem with the connection the syslog messages are lost. Is there a way to chache and resend these?Regards Marco
Hi,We have ACS 4.1 running. Everything seems to be (and has been) working fine. But when I want to add a LDAP group mapping I get an error message saying "LDAP Server NOT reachable. Please check the configuration". The ldap authentications are workin...
Hm you'r reply triggered me to have a better look at the table and the switches. And it proved that I'm not very good with switchtype's. Turns out our switches are Cisco Catalyst 3560X-24P-L which correspond with the correct 1.3.6.1.4.1.9.1.1228. So ...
Hi Michel,Yes, on the switches we see loads of macaddresses. They are devided over multiple vlans. We dont see any macaddresses except the ones off two switches. We are using snmp v3 so there is no community string and for the record, there is no @ s...
