Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I have a ASA 5545X AND FIREPOWER I have the L-ASA5545-TAMC= licence for 3 years but i can not get the control and protection license Can someone help me on this ?
Hi Every Body ,
i have a Cisco CME 10.5 and ip phone 7962 and 7811.
On the 7962 the Tranfert call does not Work properly.
When I call I can transfer automatically.But when the user to whom I transfer clinched I can not transfer again.
Also I'm not...
Hi everybody ,I have a Cisco IPICS and I want to communicate with My radio station. My Radio Controller is Motorola MTR 3000. I have My LMR RMS Router Configure and integarte int My Cisco IPICS. Actually my issue its that i don't know how to configu...
Hi i have a Cisco BE6000 Server and i want to power it when connected to the power alimentaion , And did not see power management option in The BIOS, Can Some help me on that ? Is it possible to do that wit BE6000
Hi all , I have a CME ON 2951 ROUTEUR , actually my sip phone are correctly register in the cme but i can make any call. Here is my Configuration : voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections s...
voice service voip ip address trusted list ipv4 172.17.23.123 255.255.255.255 allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip no supplementary-service sip moved-temporarily no su...
Hi Radim ,
Thanks for you answer and sorry cause i am replying late .
Actually de issue is that i can not see the E&m Port on the Motorolla MTR3000 .
I have a MIC card on the front of the MTR3000 could i use that as E&m Port ?
Thx
Hi Thanks Samuel For Your anwser, I actually want to start the server without Pressing the Power Button , I want it To start when Connecting the power source direcltly !!Is this Possible ? On some other server it is possible configure that on the BI...
