Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have a ongoing project configuring a cisco wlan with 802.1x, where microsoft network policy server is used for radius authentication.Configuring the SSID on the WLC, and the 802.1x on wlc/radius server works fine, users type in their username...
Hi,we have a new IBM Bladechassie with two Cisco nexus 4001i switches.I have configured one external port on each nexus and connected them to a cisco 6509 with 1G cisco SFP-modules and MM fibre.Both the nexus and 6509 ports are configured as trunk po...
Hello!We have some locations in our WAN with cisco 1712 routers that we want to replace.I have now bought a cisco 1921 router for test, to see if this can replace the old routers.While testing the 1921 I have ran into some problems which I hope someo...
I think you should take a look at the recommended bandwidth through the appliance in this forum post:https://supportforums.cisco.com/discussion/12101786/ironport-s660-capacityI am pretty sure your S670 is overloaded.
Hi,I tried the exact same thing as you, handheld devices with NPS authentication.Unfortunately the cisco ad agent supports only kerberos authenticated devices, not radius. And this is not possible.
Thank you for replying Jatin,After enabling accounting, I can now see the client ip-address in the nps logfile.However cisco active directory client cannot map the ip against username unless it's in the windows security event log. Im also afraid it h...
Yes, the module comes up, we are using sup-720.I have a lot of other switches connected to the module, and I've also tested this port against another switch and it works fine.sh mod:XX#sh modMod Ports Card Type Model ...
