Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Osman, I had a similar problem with a C9500-40X switch that was stuck in a boot loop. Here is how I solved my issue:1. Formatted an unused USB 16GB thumb drive with FAT32, downloaded the latest IOS-XE image file from cisco.com (cat9k_iosxe.17.06....
Here are a two suggestions:1. If you use Cisco Prime Infrastructure (or WCS) to manage your WLC, you can create a Lightweight AP Configuration Template to specify the Primary Controller Name and IP Address, and to specify a blank value (choose the f...
If you wish to deny access to a single wireless client by using their MAC address - use the following command from the CLI on the WLC: config exclusionlist add <enter mac address> <description>This was in response to j.vazquez.c issue.
Hi All,We are having a similar issue. We have a 1142N LAP at a site connected via FlexConnect to a Flex7510 WLC at a datacenter. 7510 WLC is running 7.3.X code.The following excerpt is from the LAP "show log":*Nov 18 14:19:25.127: %CAPWAP-3-ERRORLOG...
Hello, yes we current have many WGB's connected to FlexConnect LAP's. Support for connecting to FlexConnect LAP's (formerly H-REAP) has been added in WLC Code 7.3. Please refer to release notes: http://www.cisco.com/en/US/docs/wireless/controller/...
