Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there, I have an IIS Server(10.0.0.10) in my network that has a test website. I have setup a nating translation in my main router to allow people from the Internet to browse the test website using my public ip address and my router is nat/forw...
Hello there,In my vlan 40, I have Samsung Smart TV and Samsung Allshare "DLNA" software on one of my PCs in the same vlan. Everything works fine and I can watch movies on my TV streaming from my PC. Now, my brother, which is in Vlan 20, bought Samsun...
Hey there, I have basic knowledge about what is split-horizon but not how it actually works. Please refer to the topology below....According to R1's "show ip eigrp topology all-links" P 14.0.0.0/30, 1 successors, FD is 1310720, serno 75 via 13...
Hey there, I connected "FE 0/1" (cisco 1841) to "Ethernet 1/0" ( NM-4E module in 2651 router). Both interfaces' status are up but their line protocol is down. I sat both their speed to 10Mbps and their duplux to full but no luck. Is this because i am...
Pushkar, Layer2 switches do not do routing between vlans. You need a layer3 switch or a router and you need to configure that router to be a "router on a stick" Regards,
Alex, I got "ip multicast-routing dist" to work by upgrading the IOS. And your method worked Quick question!In which Cisco certification exam/course IP multicasting is covered? Abdullah,
Alex, "ip multicast-routing dist" doesn't exist in my switch. I can only see "ip multicast-routing" which i used along with the rest of your suggested configurations but with no luck. Abdullah,
fazilmohdhaneefa, If you are 100% certain about each camera's watt usage, then all your cameras are drawing 685W. Your switch supports maximum of 740W. Just to double check, use "show power inline" command to see how much wattage your cameras are cur...
