Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco Live San Diego will feature an opportunity to get hands on experience with Intersight features and programmability. Check out lab session: Configuration and Troubleshooting of Cisco Intersight with UCS - LTRDCN-2380 It will cover the following...
There is a general misconception that IP addresses were allocated per audio source ID. For example:Audio Source Codec Increment Multicast on IP Address Increment Multicast on Port Number Destination IP Address Destination Port Destination IP Address...
Hi Bijoy, With the earlier releases, there was also an option to upgrade the CIMC and the adapters in the host firmware package as part of the last upgrade step.This is listed part of the documentation."Update adapters and CIMC—If you prefer, you can...
Hi Bijoy, Thanks for clarifying the version.If you are upgrading from a release prior to 2.1(3a) or 2.2(1b), you may be impacted by CSCuh61202. This defect affects FC traffic on the Cisco 1240, Cisco 1280, and Cisco M81KR adapters. To avoid this situ...
Hi Tenaro, I think you are referring to Bijoy's question.Based on the release we are upgrading from the order of upgrade of blade can be different.If you are upgrading from a release prior to 2.1(3a) or 2.2(1b), you may be impacted by CSCuh61202. Th...
Hi Bijoy, When we activate the IOM firmware, it only applies the firmware once the FI gets rebooted.Both would work, but I would recommend Option-1 as that is the order that is listed as per the upgrade guide.Also which is the version you are trying ...
Hi Mark, I am not aware of a single document that outlines the upgrade steps for ESXI and UCS firmware.But before you do the upgrade , make sure that the ESXI version is supported with the UCS firmware.The UCS software and hardware compatibility matr...