Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,I have a Cisco Webex Desk (Not Pro) stuck in Maintenance Mode. The full error indicates that its stuck in Maintenance Mode. Actions taken:1 - Performed a factory reset via GUI/admin portal and pin hole at the rear. This has made no differenc...
Hi TeamI have setup LDAP settings. I can see the test connection is successfull however when I try to logon using my LDAP account, authentication fails. under "User Management" i have created a user account with the same alias as my AD account and ha...
hi thereI am trying to add a few devices into CPCA. v9. Its stating that credentials to Call manager servers are incorrect even though we type this in correctly. When I go through and perform a "verify", it fails each time. We have our fw ports op...
Hi allThis is a post going to all the Meetingplace Experts. We have a 8.5 audio only deployment consisting of 2 Servers in a cluster. We are after specific feature but having worked with TAC and account management we seem to be at a dead end. Here is...
Hi all,I like to ask if anyone has dealt with a similar scenario. I have 2 independent CUCM v6 clusters. I also have 2 unity environments hosting each cluster. one on version 5 and the other on unity connect v8. I need to phase out the existing old v...
1. Factory reset via pinhole at the rear works but you have to have it pressed for 10 seconds whilst the unit is powered on.Or2. Factory reset can be done via the GUI. I noticed in some situations, if the unit doesn't get an IP via wifi, it may do so...
ok seem to get to the bottom of this. Removed all credentials and deleted all historical/discovered devices. restarted services. Re-added all credentials back in - seems to resolve issue. Its weird as I can telnet to some of the devices and not othe...
Thanks Prem, yes thats the ports i have opened up on the firewalls. I would like to know if there is a way to do the packet capture from the server.I know the credentails are correct as I am using the main admin password for CUCM which has full acce...
