Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I currently have my WLC syslogging debug messages to a Syslog Server. It works fine except the messages I'm getting are rather mundane. In order to get what I really want to log I have to turn on a particular debug through the terminal. Like:d...
Everytime I try and execute this script I get "No Active Calls" come up on my phone, even though I am in the middle of a call. I have looked at the Tomcat error logs and all I can see is:com.cisco.jtapi.InvalidArgumentExceptionImpl: Terminal SEP000C...
I've been thinking of creating a service that could be used to search the users personal contacts on their Outlook/Exchange address book. However, I'm not sure how plausible this idea is.Does anybody know if it would possible to retrieve this addres...
We have the same issue. See this post, as it sounds similar to your issue. http://www.reddit.com/r/networking/comments/1t5r0z/high_outdiscards_where_do_i_begin/
I too am using Splunk for capturing WLC Syslog. With regards to the destination port of the Syslog, I don't know how to change it. However, to get around this I have set up a Splunk Forwarder with Syslog-NG. Basically Syslog-NG listens on any port...
Call Manager (4.1.3) Administrative Page > Navigate to user "ciscoipps" > on the left hand side I click "Device Association" > Searched for "SEP000CCE73F816" > ticked the check box beside that device and then clicked update.Thanks
I have created a read only user called ciscoipps and associated that user to both phones. I have also enabled CTI Application use for this user.Is there something else I am missing?
