Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello forum,I apologize if this topic has been asked before and I have researched and read till I am blue in the face.I have a couple questions regarding VLAN behavior on a UCS Mini.My Environment:Cisco UCS Mini in End Host mode.UCS Manager v. 4.0(1a...
Hey All,I am having an issue that I cannot figure out.I am currently having EIGRP neighbor adjacency flapping on multiple T1 data interfaces.This issue started when I appplied a basic QOS to the serial T1 interfaces.When the QOS policy is removed the...
Hello,I am new here so thanks in advance for any help.I recently purchased a 2921 to replace an aging router.We will using this router specifically for T1 data connections only. I am maxing this router out with T1 WIC CSU/DSU cards.I have 4- VWIC3-4M...
Thanks Wes for all your help.I wish there was a way for me to explore the behavior of the LAN uplinks manager because honestly I find it confusing and unintuitive. I personally have a hard time in UCSM as the monotonal color scheme makes it hard for...
OK I am glad to see that you are seeing the same behavior. I was worried my system was bugged. Since I only want LAN specific VLAN traffic to be present on Fabric Ports 1 and 2 , I must use a VLAN group to restrict that.But I will be removing the cur...
So for my first test, I created a Global VLAN 2030. Here is the message after creating the VLAN.Currently I have 2 Port channels per fabric.Ports 1 and 2 on each fabric are members of 1 Port channel and both are members of VLAN group "LAN".Ports...
Hey Wes,I am off till Monday so I wont be able to check until then. I dont know if creating a new global vlan will show on the fabric configs before being added to a VLAN group because I never looked but I just created a new Global VLAN recently and ...
