Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:A few days ago I noticed a team CAT6509 that the processor was increasing and to give the command.Processes show cpu sort The process that more time was consumed in the syslog, and it disabled and under the cpu. The question is I can enable TCP...
Hello: I have the need to switch SPAN ports from my access to a traffic concenntrador called Gigamon, however I have found that putting a single dedicated port SPAN is not enough, since the port is pulling packages, because it can not pass all traff...
Hello:Perform an upgrade to a pair of Nexus 5596 teams of 5.0.3.N2.1.bin version to version 5.2 (1) N1 (3) serving as the Advisory ID: cisco-sa-20130424-nxosmulti Cisco And to reset the computer I see in the error console: N5K% NOHMS-2-NOHMS_DIAG_E...
Hola:Realice un upgrade a un par de equipos Nexus 5596 de la version 5.0.3.N2.1.bin a la version 5.2(1) N1(3) atendiendo el Advisory ID: cisco-sa-20130424-nxosmulti de CiscoY al restablecerse el equipo veo en consola el error:N5K %NOHMS-2-NOHMS_DIAG...
Hola Wilson:Efectivamente un CAT6509 estaba elevando su CPU y cuando di el comando:show processes cpu sortEl proceso que estaba mas alto era el syslog, procedi a deshabilitarlo y el CPU bajo.A raiz de esto quisiera poder habilitar el syslog via TCP e...
Hello: When performing an upgrade to a Nexus with VDC's version will be the same for the whole box, whether the concept of VDC's it like having physically separate boxes. must also take into account the upgrade as necessary shall update the port cir...
Hello: The OTV is what will give you the possibility to extend the Red Lan between two points in geographically separate areas. The concept is that the OTV encapsulates the Layer 2 over Layer 3, with the proviso that there is equipment at the ends f...
Hello: 10GB FETs are limited in distance as copper cabling is 100 meters, the issue is that the FET 10 are made exclusively to work with Nexus 2000, and when you put on the chassis hardware brand failed unless you put the command (mode FEX). What...
Hello First I would recommend working with version A2 (3.6a) as this will give you more stability. You do not mention if your balancers work in FT or just a manual redundancy. FT must be careful that the command (show ft group summary) always show a...
