Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to connect my new controller to sccm. However when I try it only resolves a ipv6 address and that is not routed through my network. 9800-cl#telnet smartreceiver.cisco.com 443Trying 2A04:E4C7:FFFE::F, 443 ...% Destination unreachable; gate...
I have a switch stack that I have to clear the arp and mac table every morning for some certain users to be able to work. Has anyone had these issues or know of a bug for the version of code I am on? I know this isn't a lot of info but as soon as I s...
I work for a large company. We have many iPads used for scheduling zoom room meetings and they are all on the same SSID at all locations. These iPads will go through a stretch of having a solid connection then all of the sudden many office will start...
We are merging with another company and as a temporary solution until we can fully merge into one company we are going to run 2 completely separate wireless networks. Currently the offices are running a full Meraki wireless solution. We are going to ...
The AP with the issue is not a 1850 series it is a AIR-AP3802I-B-K9. We are luckily running 2 5520 controllers. I am not sure why this bug is effecting only one controller and not the other when they were both upgraded the exact same way.
Thanks my Secure CRT was doing it for some reason, but I have since corrected it. That is a pretty awesome tool. I have been having issues at a site whose wireless coverage is extremely good. I am noticing that users that are complaining are jumping ...
Well Dab Nabit changing to a .txt I ended up with the same results. I wonder if it is throwing it back because of thedate and time stamp at the beginning of each line
I have tried this and when I upload the .log file it spins for a minute then it just goes back to the same screen and it gives me no output. Does the file need to be in a different format?
Wondering if anyone found a solution to this. At my office we are getting new Logitech Tap Schedulers. At 1st none of these could connect to the WPA2/AES128 PSK network but if I made a open one it would connect fine. But out of the blue 90% finally c...
Thank you for responding. We have a SSO pair 9800-40 in 1 DC that hosts about ½ of our APs and another SSO pair of 9800CL in a different DC that supplies a HA failover for the APs on the other controller. We are on 17.9.3 because that is the only ver...
