Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have tried everything I can think of and everything I found on the net, but nothing works.I attached my config minus a few lines.This is the relevant part of my config:: Saved:ASA Version 8.2(5)!hostname ASA5510namesname 12.33.204.205 storename 172...
I have a Cisco 3750X 48 port switch connected via a OM-3 fiber optice cable a Cisco 2960S 24 port switch via the 10G-SR SFP+ transceivers. I am trying to determine the maximum throughput of the link.In theory, the link should be able to do 1310720 ...
Does anyone know if the 2901 router set up as a CUBE/voice gateway will work with a SIP trunk running at 100Mbps?The connection is an ethernet handoff from fiber optic link to the ISP.I am getting conflicting information from everyone I talk to about...
Simple question, prob already know the answer but I want to be sure...Does it matter as far as performance and/or redundancy if you connect the switches via the stacking cables in a crossed fashion with one link connecting the top and bottom switch o...
Sorry for the long absence, I was on vacation. I tried hair-pinning and could not make it work.The requirements have changed anyway so I no longer require outside access. They can connect to the DMZ from the inside.Thanks for your and everyone's he...
The PRI and the SIP are both from AT&T.
I agree it appears to be on the telco's end. The keep denying it and telling me everything is ok so I want to be sure I am not missing something on my end.
What would cause that to happen? Is it a telco issue or a configuration problem?
Do they bounce the setup back if there is a problem with the sent call data?
I attached a q931 debug that shows 2 calls.
The call above the dashed line in the file is t...
