Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I created a customer service container, packaged into an OVA following the sporadic instructions found on the various web-sites. The issue I'm hitting is the OVA is being unpacked and it is looking for a XML file. In one slide deck you talk about a l...
After I update the name of a device with the API (/op/apService/accessPoint) the name that is displayed when I look at the device details has the old name stuck in it. It seems to update after some time and the Summary page shows the correct new name...
I've been working with the API in Prime Infrastructure to update the information for ~1,500 access points. I'm a little frustrated. It seems I have to specify a value for the name and IP address for all 3 characters. If I send empty strings I get an ...
Hi, I am curious what you folks think I should do in this situation. I have a pair of ASR routers running BGP multi-homed to a single ISP. Among other connections I have a pair of VLANs on the back side of the ASR routers where my global unicast addr...
I'd like to know if it is normal to not be able to traceroute or ping connected VPN clients from the ASA command line? The VPN client and connection works well currently. I can ping/connect to inside hosts from the VPN and vice versa. I cannot howeve...
Doh, ICMPv6 destination unreachable is type 1 and packet too big is type 2 unlike ICMP (v4) where both functions fall underneath ICMP type 3 destination unreachable (because of DF bit set).
Good catch.
This was because the device was running 3.13. I've learned this feature wasn't added until 3.17. In case anyone else finds this thread, make sure you're running an up to date IOS.
Suresh, can you explain your question or the problem you are trying to solve in more detail?
Are you looking to deploy a segment with IPv4 or IPv6 and be able to provide connectivity between to the two protocols?
If you are looking to deploy an IPv...
