About Prakash Parvathala

Prakash Parvathala · 07-18-2016

I am currently working with a customer using prime 2.1. They are also looking to upgrade to Prime 3.0. There are over a 1000 Access Points in Prime spread across various sites in Ireland and the US. I am looking to setup email notifications that are ...

Prakash Parvathala · 08-17-2016

Hi Rob It says you have to have management interface configured and your WLC need to sync with a NTP server to get it working. Configure those with initial script using service port basic connectivity & then download the backup config. See below post...

Prakash Parvathala · 07-29-2016

High utilization can be caused by the following: High density of access points on channel or co- channel. Example- excessive access points on the same channel that contribute to interference, beacons, probe responses and probe request. All of which ...

Prakash Parvathala · 07-26-2016

Distances from the ROOT AP (RAP) to Mesh APs (MAPS) is 1000-4000 Ft with distances between MAP to MAP around 500-1000 Ft (this is because the MAPs are lower to the ground) and client distance from MAP for 2.4 GHz access is roughly 300-500 Ft (further...

Prakash Parvathala · 07-25-2016

HI Enable RADIUS Change of Authorization (CoA) ... Enables ISE to act as a AAA server when interacting with the client at IP address 10.0.56.17. RADIUS Servers Configuration. Configure the switch to interoperate with Cisco ISE acting as the RADIUS so...

Prakash Parvathala · 07-25-2016

Hello Rashmi, Please look into the below treads it may help you http://www.cisco.com/c/en/us/support/wireless/aironet-1830-series-access-points/products-installation-and-configuration-guides-list.html http://www.cisco.com/c/en/us/solutions/collateral...

Member Since	‎10-18-2012 03:37 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	378
Total Helpful Votes Received	149

User Statistics

User Activity

how to setup email notification in prime2.1 from access points

Hi Rob

High utilization can be

Hi

HI

Hello Rashmi,