Hello Team,I am facing issue in IP Netflow Exporter Packet sending problem in C2960X. Records are added and client send packets but exporter not sending to Netflow Stealthwatch device. SW1#show flow exporter statisticsFlow Exporter NETFLOW_EXPORTER:P...
Hello Team, Kindly share the understanding of "Application performance assurance issues" in Cisco Prime Infrastructure. And how to find this through on gui or cli. podasrinivasulu@gmail.com
Dear Team, Kindly help to find the root cause of Nexus 9K C93180YC-FX Device Unsupported error showing on Cisco Prime Infra 3.4, however, Nexus 9K 9508 device has no error.
I am not be able to enable the TKIP for WPA2 with Wave 2 access points and controller firmware above 8.5.xx Please find waring message seen. Warning! WPA2 TKIP cipher is not supported on Wave2 APs for WLAN 2 Please share the all possibility to enable...
FYI, flow record FLOW_RECORD_inputdescription NetFlow input record format to send to SWmatch datalink mac source address inputmatch datalink mac destination address inputmatch ipv4 tosmatch ipv4 protocolmatch ipv4 source addressmatch ipv4 destination...
Yes find the same-Model-WS-C2960X-48FPD-LVersion- 15.2(7)E3Netflow version- 9Config**** flow record FLOW_RECORDmatch ipv4 source addressmatch ipv4 dest addressmatch ipv4 protocolmatch tra source-portmatch tra dest-portmatch ipv4 tosmatch int output...
Dear Balaji,Your example is correct but below command not working-"match interface output". SW1(config-if)# ip flow monitor IPv4_NETFLOW sampler NETFLOW output (input working*)% Flow Monitor: 'IPv4_NETFLOW' could not be added to interface...
In some previous years, I think this model was supported but is currently unsupported. But not an issue thanks to all @marce1000 @Leo Laohoo for your prompt supports and reply.