Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block s...
Hi, I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block ...
You need disable NTP in the WLC and set the a time to before Dec/2022.Case after it the AP still get the same mensage "%PKI-3-CERTIFICATE_INVALID_EXPIRED", you should set the clock in the AP over console: clock set 19:00:00 Oct 30 2020
Hello, It's considering that no RF signal loss happening, so could you try changing these in your WLAN as good practie to apple devices (probably not solve but improve the apple devices) Local Profiling ............................. Disabled --> Ena...
Sounds like no comunication between the AP and WLC, as no CAPWAP response after broadcast requirement . If the WLC was not changed the firmware version (please ensure, because it would get incompatible SW), you could try it: 1- Ensure the WLC countr...
If you are in the same L2 network to connect the RP port to both WLCs, you just need set any IP/Gateway (same broadcast must be the same gateway/subnet) to stablish the comunication. And go to set the "SSO" feature, so the secondary AP will auto st...
