Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently working with a customer using prime 2.1. They are also looking to upgrade to Prime 3.0. There are over a 1000 Access Points in Prime spread across various sites in Ireland and the US. I am looking to setup email notifications that are ...
Hi Rob
It says you have to have management interface configured and your WLC need to sync with a NTP server to get it working.
Configure those with initial script using service port basic connectivity & then download the backup config. See below post...
Distances from the ROOT AP (RAP) to Mesh APs (MAPS) is 1000-4000 Ft with distances between MAP to MAP around 500-1000 Ft (this is because the MAPs are lower to the ground) and client distance from MAP for 2.4 GHz access is roughly 300-500 Ft (further...
HI
Enable RADIUS Change of Authorization (CoA) ... Enables ISE to act as a AAA server when interacting with the client at IP address 10.0.56.17. RADIUS Servers Configuration. Configure the switch to interoperate with Cisco ISE acting as the RADIUS so...
Hello Rashmi,
Please look into the below treads it may help you
http://www.cisco.com/c/en/us/support/wireless/aironet-1830-series-access-points/products-installation-and-configuration-guides-list.html
http://www.cisco.com/c/en/us/solutions/collateral...
