Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Related to https://community.meraki.com/t5/Wireless-LAN/MR76-Extending-the-LAN-for-wired-clients-bridge-mode-using/m-p/208808#M28622Hello All, on my original post above we were trying to use an MR76, but since its unable to use port profile we are no...
We are in a need to extend a group of devices connected to a industrial POE Switch located in a shack outside the building and a bit far out that we cant place the AP inside the shack so the AP needs to be weather proof thus the use of an MR76.connec...
Hello All,
I basically need to copy and image out from our switch. the switch has the Mgmt-intf VRF and Fa0 is assigned to that VRF and that is where the management IP is configured.
We can ssh to the switch in question. but for some reason the s...
Hello Community,
I wanted to know what is the maximum number of VRF instance and the number of routes per VRF instance can a ISR4451 with 2GB of data plane memory and 4GB of control/services plane mem. im looking for the same info as presented on a...
Hi, Need a guide that will help me prevent the message "Memory full, run clear telephony-service ephone-attempted-registrations to refresh the storage" from being logged into the 2911 logs. When we do a sh log, that is the only message we get to see ...
Thank you for your response both, is there no way to set this with a limited set of APs? because what is being suggested would mean all our AP, network wide, if we plug a device on any ethernet port on any AP will pass traffic since SSID authenticati...
Was anyone able to make this work? we are looking to use a aironet 1552e to extend a group of devices off a small shack outside the building shack devices > industrial switch with POE > aironet 1552e outdoor ap > wireless connection to meraki mesh AP...
Thank you, we got away by configuring a tftp server close to the switch and pulled the image that way. initially tftp was hanging midway when we transfer the file back state side directly from the switch. That is why we thought a TCP way of transfer ...
I know this thread is kinda old but incase anyone passes by this thread looking for an answer to the same question as the original poster.test voice port x/x/x si-reg-read 29 1This command can help in detecting if the line connected to the port has...
